Sanya Hi Clean Clean Cleaning Co.,LtdSanya Hi Clean Clean Cleaning Co.,Ltd
Fax: 0898-8822657
Tel: 0898-8822657
Scope of services

Hard floor wax and wax method

Hard floor wax and wax method
Cleaning tools needed
A washing/polishing machine (standard speed)
Second to wax to clean the pad (black) and driver CD
Three water machine

Five powerful cleaning pads (holder and a long handle)
Six-polishing machine (high speed or high speed)
Seven Polish to clean the pads (white) and driver CD
Eight sweeps
92 mopping systems and foxglove
Ten wax with a MOP and bucket
11 industrial gloves
12 dewaxing Agent
13 artificial white vinegar
14 water quality wax
XV pH indicating paper
16 placards
18 square plastic bag
Cleaning methods and procedures
All needed equipment will be ready, also check the appliance is intact, check plugs, wires, and so on.
II place the signs in conspicuous places.
Three to open all doors and Windows.
Four label in accordance with manufacturers instructions will be the right amount of dewaxing agent added to water in.
Five using this drag will be about ten square meters of floor wax.
Six of approximately 5-10 minutes.
Seven at the most distant from the entrance began to wash, using overlapping method.
Ensure dewaxing agent when eight drums in the rear, the wires behind the machine while the machine is not in the water.
Nine repeated (v) to (VIII) until the entire floor is finished.
Ten wash is finished, clean the pad drive disc removed, on the machine is then placed in a plastic bag.
11 powerful wipe pad scrub head and the wall.
12 dewaxing agent is sprayed onto walls or other places, wipe immediately with a cloth and water.
13 use water suction machine suction brush on the ground after the grout. Water absorption, water machine starting at dry and then get wet.
14 in a MOP bucket system, half a cup of artificial rujiu of white vinegar in a litre of water. Just brushed the floor with a MOP end of withdrawal of water (more water). If it is not allowed to use vinegar, use lemon. Water, use water suction machine to floor drain. Check floor PH indicating paper, if a PH higher than nine, floors shall be returned to the water, and then check again.
XV during and after the floor and let it dry.
16 starting from the most distant from the entrance, with wax with mops, wax on the levels and thin first layer of wax. Waxing avoid painted onto the wall. Polishing by a layer of wax on each time, reflective, and good brightness.
17 let the wax dry.
18 if necessary, polishing machine, and wax with drag-and-sweep debris removed.
On 19, a second coat of wax. In painting, the second with the first floor into a right angle.
20 let the two layers of wax dry.
21 if necessary, polishing machine, and wax with drag-and-sweep debris removed.
22 all equipment collected, washed back into the storage room.
-Should wear gloves while working.
-Check the electrical machinery, with particular attention to plugs and wires.
-All parts of the machine after installed, plug the plug into the socket.
-Avoid spray wax or wax.
-As far as possible behind the wire into the machine, off the wet ground.
-Dewaxing agent barrel was placed in the rear at any time.
-When the machine is not in use, the handle upright.
Waxing marble and granite is quite different solutions, the whole granite with a strong acid solution many small holes on the surface.
Partial wax, wax, water concentration is 10%, with watering can spray the cleaner was firmer. In addition, the permeability of fine particles is stronger.
Abrasive wax, itself with a wax and wax, put the wax softening and polishing hard instead.
Equipment maintenance
-Drag the MOP and sweep clean when stored upside down.
-Pour out the rest of the wax water, bucket of washing to dry, upside down storage.
-Wash clean the pad and allowed to dry.
-Wipe wax removed bottom clean and dry.
-Work, immediately wipe the pad from the machine take off at the end of, or clean the pads and drive damage.
Black mat (), after use immerse the water barrels in the cleaning, or use water soft wash. Acidic detergent can add a little wax (base) to be neutral. BACK